28
Switching off water softening
system
Note
To avoid damage to the appliance, only
switch off the water softening system in the
following cases:
● The water hardness is max. 26°E and
you are using combined detergents
with salt replacement substances. Ac-
cording to manufacturers, combined
detergents with salt replacement
substances can generally only be
used up to a water hardness of 26°E
without adding special salt.
● The water hardness is 0 - 8°E. You do
not need to use special salt.
1.
Press .
2. Hold programme button A and press
repeatedly until the display
shows H:xx.
3. Release programme button A and
.
a Programme button A flashes and the
display shows H:04.
4. Press programme button C re-
peatedly until the display shows
H:00.
5.
Press to save the setting.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs reheating of the water
softening system at regular intervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all programmes.
It will increase the run time and con-
sumption values, e.g. water and electri-
city.
Overview of consumption values with regeneration the water
softening system
Here you can find an overview of the maximum additional running time and con-
sumption values during regeneration of the water softening system.
You can find the column applicable to your model in the quick reference guide ac-
cording to its water consumption in the Eco50° programme.
WATER CON-
SUMPTION IN
LITRES (DE-
PENDING ON
MODEL)
REGENERA-
TION OF THE
WATER
SOFTENING
SYSTEM AFTER
X RINSE
CYCLES
ADDITIONAL
RUNNING
TIME IN
MINUTES
ADDITIONAL
WATER CON-
SUMPTION IN
LITRES
ADDITIONAL
POWER CON-
SUMPTION IN
KWH
6.5 / 6.7 8 7 5 0.05
7.5 / 7.7 7 7 5 0.05
9.5 6 7 5 0.05
To Next Page
Loading...
Need help?
General
