46
FAULT CAUSE TROUBLESHOOTING
E:25 lights up. Wastewater pump is
blocked.
● Clean the wastewater pump.
→"Clean wastewater pump",
Page57
Cover of the wastewa-
ter pump is loose
● Secure the cover of the
Wastewater pump
→Page57 so it clicks into
position.
E:27 lights up. Mains voltage is too
low.
This is not a fault on the appli-
ance.
1. Contact an electrician.
2. Have the mains voltage and
electrical installation
checked by an electrician.
Another error code ap-
pears on the display.
E:01 to E:30
A technical fault is
present.
1.
Press .
2. Unplug the appliance or
switch off the fuse.
3. Wait at least 2minutes.
4. Insert the mains plug of the
appliance in a socket or
switch on the fuse.
5. Switch the appliance on.
6. If the problem occurs again:
● Press .
● Turn off the water tap.
● Pull out the mains plug.
● Contact Customer Ser-
vice and give the error
code.
Washing results
FAULT CAUSE TROUBLESHOOTING
Tableware is not dry. The selected rinse aid
is not suitable or has
been used too spar-
ingly.
1. Add Rinse aid →Page29.
2. Set the amount of rinse aid
to be dispensed.
Programme or pro-
gramme option has no
drying phase, or the
drying phase is too
brief.
● Select a programme with
drying, e.g. intensive, strong
or ECO programme.
To Next Page
Loading...
Need help?
General
