IKEA PROFFSIG - Error Codes and Fault Displays

44
FAULT CAUSE TROUBLESHOOTING
Appliance door does
not open at the end of
the Eco 50° pro-
gramme.
If the screws used here are
too long, this may deactivate
Eco drying.
The safety device will
switch Eco drying off.
● Call Customer Service.
Appliance door auto-
matically opens too
wide at the end of the
Eco 50° programme.
Door is not correctly
adjusted.
● Adjust the appliance door as
described in the installation
instructions.
The door gap must be at
least 70mm - 100mm.
Wrong screws used to
adjust the door gap.
● Use size 4X30 screws to ad-
just the door gap.
The screws are included in
the scope of supply.
If the screws used here are
too long, this may deactivate
Eco drying.
Error code / Fault display / Signal
FAULT CAUSE TROUBLESHOOTING
E:07 lights up. Intake opening is
covered by items of
tableware.
E:12 lights up. Appliance has detected
calcified heating ele-
ment.
1. Descale the appliance.
2. Operate the appliance with
the Water softening system.
E:14 lights up. Water protection sys-
tem is activated.
1. Turn off the water tap.
2. Call Customer Service.
E:15 lights up. Water protection sys-
tem is activated.
1. Turn off the water tap.
2. Call Customer Service.
E:16 lights up. Water is continuously
running into the appli-
ance.
1. Turn off the water tap.
2. Call Customer Service.
E:18 or indicator for
water supply lights up.
Supply hose is kinked. ● Install the supply hose
without kinks.
Water tap is turned off. ● Turn on the water tap.
Water tap is jammed or
furred up.
● Turn on the water tap.