IKEA PROFFSIG User Manual

50
FAULT CAUSE TROUBLESHOOTING
Water marks on plastic
parts.
Due to laws of physics
droplet formation on
plastic surfaces is un-
avoidable. After drying
water marks are vis-
ible.
● Select a more intensive pro-
gramme.
● Position tableware at an
angle.
→"Arrange tableware",
Page34
● Use rinse aid.
→"Rinse aid", Page29
● Set the water softening sys-
tem higher.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the door.
Detergent substances
are deposited there.
These coatings cannot
generally be removed
with chemicals.
● Change your detergent
→Page30.
● Clean the appliance mechan-
ically.
White coating is depos-
ited in the appliance in-
terior.
1. Set the water softening sys-
tem correctly.
In most cases you will need
to increase the setting.
2. Change your detergent if re-
quired.
Special salt dispenser is
not screwed tight.
● Screw the special salt dis-
penser tight.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door.
Detergent substances
are deposited there.
These coatings cannot
generally be removed
with chemicals.
● Change your detergent
→Page30.
● Clean the appliance mechan-
ically.
The hardness range is
set incorrectly or the
water hardness is
greater than 62°E
(8,9mmol/l).
● Set the Water softening sys-
tem →Page26 to the water
hardness or add special salt.
3in1/organic/eco deter-
gent is not effective
enough.
● Set the Water softening sys-
tem →Page26 to the water
hardness and use separate
detergents (proprietary de-
tergent, special salt, rinse
aid).

IKEA PROFFSIG Specifications

General

Brand	IKEA
Model	PROFFSIG
Category	Dishwasher
Language	English