IKEA SMAKSAK - Setting the DURATION Function; Setting the END Function; Setting the TIME DELAY Function; Setting the MINUTE MINDER

Setting the END function
1. Set a heating function. Press to
conrm.
2. Press again and again until starts
to ash.
3. Turn the control knob to set the hours
and press to conrm. Turn the control
knob to set the minutes and press to
conrm.
At the set End time the signal sounds for 2
minutes.
and time setting ash in the
display. The oven turns o automatically.
4. Press any button or open the oven door
to stop the signal.
5. Turn the knob for the heating functions
to the o position.
This function is not available for Pyrolysis
and for some oven functions.
Setting the TIME DELAY function
1. Set a heating function. Press to
conrm.
2. Press again and again until starts
to ash.
3. Turn the control knob to set the minutes
for DURATION time and press to
conrm. Turn the control knob to set the
hours for DURATION time and press
to conrm.
The display shows ashing .
4. Turn the control knob to set the hours
for END time and press to conrm.
Turn the control knob to set the minutes
for END time and press to conrm.
The display shows and the set
temperature.
Oven turns on automatically later on, works
for the set DURATION time and stops at the
set END time.
At the set END time the signal sounds for 2
minutes. and time setting ash in the
display. The oven turns o.
5. Press any button or open the oven door
to stop the signal.
6. Turn the knob for the heating functions
to the o position.
You can change the heating function and the
temperature after you set the TIME DELAY
function.
Turn the knobs to the o positions to stop
the TIME DELAY function.
Setting the MINUTE MINDER
Minute minder can be both set when the
oven is turned on and o.
1. Press
again and again until starts
to ash.
2. Turn the control knob to set the seconds
and than the minutes.
• Press
one more time to set the
minutes
• Press two more times to set the
hours
3. Press to conrm.
4. The MINUTE MINDER starts automatically
after 5 seconds.
After 90% of the set time the signal
sounds.
5. When the set time ends the signal
sounds for 2 minutes. "00:00" and
ash in the display. Press any button to
stop the signal.
COUNT UP TIMER
Press again and again until the display
shows time without any symbols.
Using the accessories
Warning! Refer to Safety
chapters.
Inserting the accessories
Wire shelf:
ENGLISH 15