IKEA SMAKSAK - Technical Data

Problem Possible cause Remedy
The water comes out of the
cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with a
cloth or sponge. Add the cor‐
rect amount of water to the
cavity embossment. Refer to
the specic procedure.
The lamp is turned o. The Eco Fan Cooking function
is turned on.
Normal behaviour of the Eco
Fan Cooking function. Refer
to "Daily Use" chapter, Heat‐
ing Functions.
The door is locked. There was a power cut. Check the power supply.
Service data
If you cannot nd a solution to the problem
yourself, contact an Authorised Service
Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on the
front frame of the oven cavity. Do not
remove the rating plate from the oven cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
Technical data
Technical data
Dimensions (internal)
Width
Height
Depth
480 mm
361 mm
416 mm
Area of baking tray 1438 cm²
Top heating element 2300 W
Bottom heating element 1000 W
Grill 2300 W
Ring 2400 W
Total rating 3490 W
ENGLISH 29