Problem Possible cause Remedy
The core temperature sensor
does not operate.
The plug of the core temper‐
ature sensor is not correctly
installed into the socket.
Put the plug of the core tem‐
perature sensor as far as
possible into the socket.
Steam and condensation set‐
tle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
The display shows "C2". You want to start the Pyroly‐
sis or Defrost function, but
you did not remove the core
temperature sensor plug
from the socket.
Remove the core tempera‐
ture sensor plug from the
socket.
The display shows "C3". The cleaning function does
not operate. You did not fully
close the door, or the door
lock is defective.
Fully close the door.
The display shows "F102".
• You did not fully close the
door.
• The door lock is defective.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows "F102"
again, contact an Author‐
ised Service Centre.
The display shows an error
code that is not in this table.
There is an electrical fault.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
an Authorised Service
Centre.
There is no good cooking
performance using the func‐
tion: Direct Steam.
You did not turn on the func‐
tion: Direct Steam.
Refer to "Activating the func‐
tion: Direct Steam".
There is no good cooking
performance using the func‐
tion: Direct Steam.
You did not ll the cavity em‐
bossment with water.
Refer to "Activating the func‐
tion: Direct Steam".
The water in the cavity em‐
bossment does not boil.
The temperature is too low. Set the temperature at least
to 110 °C.
ENGLISH 28
To Next Page
Loading...
