cavity.
Make sure that the core temperature
sensor stays in the meat and in the
socket during the cooking.
When you use the core temperature
sensor for the rst time, the default core
temperature is 60 °C. While
ashes,
you can use the control knob to change
the default core temperature.
The display shows the symbol of the core
temperature sensor
and the default core
temperature.
4. Press to save the new core
temperature, or wait 10 seconds for the
setting to be saved automatically.
The new default core temperature is
displayed during the next use of the core
temperature sensor.
When the meat is at the set core
temperature, the symbol for the core
temperature sensor
and the default core
temperature ash. A signal sounds for two
minutes. The oven turns o automatically.
5. Press any button or open the oven door
to stop the signal.
6. Remove the plug of the core
temperature sensor from the socket.
Remove the meat from the oven.
Warning! Be careful when you
remove the tip and plug of the
core temperature sensor. The
core temperature sensor is hot.
There is a risk of burns.
The Duration and End do
not operate with the core
temperature sensor.
The oven calculates the
approximate cooking time, it may
change during cooking.
You can change the core temperature at
any time during the cooking:
1. Press
:
• one time - the display shows the set
core temperature which changes
every 5 seconds to the current core
temperature.
• two times - the display shows the
current oven temperature which
changes every 5 seconds to the set
oven temperature.
• three times - the display shows the
set oven temperature.
2. Use the control knob to change the
temperature.
Using the telescopic runners
Keep the installation instructions
for the telescopic runners for
future use.
With telescopic runners you can put in and
remove wire shelves and trays easily.
Caution! Do not clean the
telescopic runners in the
dishwasher. Do not lubricate the
telescopic runners.
ENGLISH 17
To Next Page
Loading...
Need help?
General
