PRECAUTIONS FOR OPERATION
(I) Never let this unit fall nor give it a strong
shock.
Otherwise, it will be damaged.
(2) Do not detach the cabinet unless otherwise
necessary.
High-voltage parts are contained in the
cabinet and they are very dangerous if you
touch them. Only the qualified service
engineers are allowed to adjust the inside of
the cabinet.
(3) This color monitor has been adjusted to the
signals conforming to each broadcasting
standard.
So, it cannot be used for signals of different
broadcasting standards.
Be sure to operate the color monitor within
the voltage range marked on its back.
( 4) If the cabinet or screen is stained, wipe with
soft cloth. At this time, avoid using benzine
or thinner.
Otherwise, the paint may peel away.
(5) Note that, if video signals with high
luminance are monitored on the CRT for
long, the CRT may suffer from sticking.
(6) Avoid using and storing this unit in the
following places :
• Hot ( +40"C or more) or cold (O"C or
less) places.
Especially in a place where this unit is
exposed to the direct rays of the sun, the
cabinet may deform and the fluorescent
screen of the CRT may be deteriorated.
• Humid and dusty places.
• Places where there is much vibration.
• Places where strong magnetism is
generated.
• Places exposed to rain or water.
• When storing this unit for long or
transporting it, pack it up in the supplied
carton or equivalent beforehand.
■
Even if no picture can be monitored by
performing daily adjustment or something
seems to be wrong with this unit, do not
dismantle this unit by yourself. In such a
case, contact the service department of
lkegami.
■
Should this unit fail within one year after
your acceptance, it will be repaired free of
charge unless such a trouble is not caused by
operator's mishandling or misuse.
However, the CRT and fuses are not covered
by the warranty.
■
The specifications and appearance of this unit
may be changed for further improvement
without prior notice.
PRECAUTIONS FOR HANDLING OF REMOTE CONNECTOR
Follow the following precaution in order to obtain the prescribed performance.
Precaution
Use the shielded cable for the remote connector and attach the core(supplied or equivalent) for prevention of
electromagnetic waves emission to it.
V
17SER1ES·,0208, VOL5 (U) (E)
To Next Page
Loading...
Need help?
General
