SECTION 4 ILMOR MV8 OWNER’S MANUAL
4-4 © 5/2013 Ilmor Marine, LLC, Version 1.0
CHECK THE POWER STEERING FLUID
FOR ENGINES WITH INTEGRAL RESERVOIR
(IF EQUIPPED)
is procedure applies to boats equipped with power steering systems.
Because this process should be completed while the engine is cool (in order
to avoid burns), it is recommended that this check be completed prior to
starting the engine.
1. Center the steering and stop the engine.
2. Locate the power steering pump at the port side, front of the engine
and remove the ll cap with integrated dipstick (level gauge).
3. Proper uid level is at the FULL mark.
4. If necessary, add uid to specied level. Use only uid as outlined in
Engine Specications on page 11-1.
1
2
3
1) FULL HOT Mark
2) FULL COLD Mark
3) ADD Mark
NOTICE: If power steering fluid is not visible, contact your Ilmor service
center immediately. Severe engine damage could occur.
NOTE: Power steering uid does not require changing.
For remote power steering reservoir systems, see the boat manufacturer’s
manual for proper maintenance instructions, or contact your authorized
Ilmor service center for assistance.
To Next Page
Loading...
