ILMOR MV8 - EMISSIONS

© 5/2013 Ilmor Marine, LLC, Version 1.0 9-1
Section 9
EMISSIONS
It is extremely important that attention be given to the gaseous emissions
throughout the life of the engine. It is the owner/operator’s responsibility
to ensure that the engine maintenance is performed as described in this
Owner’s Manual, in order to maintain emissions levels within the certied
standards. e owner/operator(s) must never modify the engine in any
manner that alters the allowable gaseous emission levels to exceed the
certied specications.
EMISSIONS CONTROL INFORMATION
LABEL
At the time of manufacture, each engine is axed with a tamper-resistant
Emission Control Information (ECI) label. is label arms the required
emissions statement, along with the engine “family” name, as well as the
engine displacement. e engine serial number is stamped on a at boss
surface on the rear block, near the corner of the cylinder head. e date of
manufacture is indicated by punch holes at the bottom of the ECI label.
ECI labels must not be removed or tampered with by anyone.
If replacement decals are needed, contact Ilmor Marine, LLC, promptly.
Engines with the CE mark (present in the lower right corner of the ECI
label) arm that the Declaration of Conformity applies. e Declaration of
Conformity attests the engine’s conformance to the appropriate European
Community Directive. e ECI label is located on the electrical component
mounting bracket on the rear of the engine.