SECTION 7 ILMOR MV8 OWNER’S MANUAL
7-4 © 5/2013 Ilmor Marine, LLC, Version 1.0
8. Reattach the oil drain plug to the end of the hose and rell the
crankcase through the oil cap opening on the ll neck. Hand-tighten
the oil cap.
9. Check the oil level with the dipstick. Check that the oil level is between
the FULL and ADD marks on the dipstick. If the oil drain hose and
water lines are on the port side of the engine as it came from the factory,
cable-tie the lines to keep them from coming in contact with hot areas
in the engine compartment.
10. Aer the warm-up period the rst time aer the oil change, turn OFF
the engine. Disconnect the engine safety starting switch and leave the
throttle/shi control lever in neutral. Open the engine compartment
cover and verify that there are no leaks around the new oil lter and
tting, the drain line or the valve covers.
11. Add more oil as necessary and recheck levels if oil is added.
NOTICE: Always use the recommended engine oil. Failure to follow the
engine oil recommendation listed in this Owner’s Manual can result in
accelerated engine wear and engine component failure. Engine damage
due to incorrect oil usage, oil changes and oil levels, or other failure to
follow engine oil procedures can be costly and may void the warranty.
To Next Page
Loading...
Need help?
General
