All user interfaces of the Setup Wizard are described in the online help.
To exit the Setup Wizard, you must deactivate it in the LAUNCH SCAN
APPLICATION tile.
To start the Setup Wizard after a reboot of the scanner, reactivate it in the
SETUP DEVICE section of Scan2net.
➢ Open a tab in a web browser and enter the IP address assigned to the
scanner.
➢ The Scan2Net window is displayed.
➢ Click on SETUP DEVICE, then click POWERUSER.
➢ Enter "Poweruser" as login name and password.
➢ Select SETUP WIZARD in the "Administrative Settings" menu.
➢ In "Setup Wizard" menu, select YES.
To Next Page
Loading...
