Image Access Bookeye 5 V2 - Restoring User Settings

System Restore
36
System Restore to User Settings
Set Restore Point
Step
Action
1
Open a tab in a web browser and enter the IP address assigned to
the scanner.
2
The Scan2Net window is displayed.
3
Click on SETUP DEVICE, then click POWERUSER.
4
Enter "Poweruser" as login name and password.
5
Select SYSTEM RESTORE in the "RESETS & DEFAULT VALUES" menu.
6
Select SET RESTORE POINT.
Please wait until the process is finished and the READY message is
displayed. The process takes about 1 – 2 minutes.
System Restore
Step
Action
1
Open a tab in a web browser and enter the IP address assigned to
the scanner.
2
The Scan2Net window is displayed.
3
Click on SETUP DEVICE, then click POWERUSER.
4
Enter "Poweruser" as login name and password.
5
Select SYSTEM RESTORE in the "RESETS & DEFAULT VALUES" menu.
6
Select RESTORE SYSTEM.
The device will reboot immediately. Then, the System Restore is
performed. This process will take about 1 – 2 minutes. Finally, the device
will perform a second reboot into the restored system.
End of restore process.