/ /
Page 44 Manual
C.2.4 Transport
The settings available here are similar as described in chapter C.1.1 to C.1.1.6.
Picture 33: Transport parameters
C.2.4.1 Paper Feed Delay
Defines the delay between inserting the document into the
transport path and the transport start.
C.2.4.2 Scan Mode
(Default)
Feeds the document in the scanner until the camera recognizes the
document edge; then the document returns to the start position.
The document transport start directly after the application sends the
stat
command. This mode is recommended for documents with
irregular document edges.
Transports the document into the scanner until the photo sensor in
the transport path detects the paper edge.
(Full automatic
mode)
The scan sequence starts directly when the application sends the
start command.
Scanning stops automatically when the length defined with the slider
Paper length (see Picture 11) is reached.
Then the document is transported in reverse direction for the length
defined with the Overlap slider.
This position defines the beginning of the next part of the document.
The next scan sequence starts again when the start command is
send.
This will be rep
eated until the scanner sensors recognize the
document end.