HOW TO USE THE PULSE SENSOR
The treadmill features a state-of-the-ad cordless pulse
sensor, specially designed for greater acoumcy, com-
fort, and dureblrd.y.Please read the following
Instructions before using the pulse sensor.
HOW TO INSTALL BATrERIES
The pulsesensorrequirestwo "AAA" batteries.
Alkalinebatteriesare recommended.To Install batter-
ias,firstslideoffthe bettew cover as shownbelow.
J _Battedes
Note the markings inside the battery compartment
showing which direction batteries must be turned.
Insert two "AAA" batteries into the battery compart-
ment. Replace the battery cover.
HOW TO ADJUST THE HEADBAND
For the pulse sensor to functionpropedy, the head-
band must fit snugly around your head, without being
uncomfortable. To adjust the headband, insert the
adjustment
tab through
the appmpd-
ate hole in
the head-
band.Note:
Each time
yOU exer-
cise, the
headband
may expand
slightly dur-
Ing the first
few minutes
•of use. it may be necessary to readjust the head-
band pedodlcally.
HOW TO PUT ON THE PULSE SENSOR
Rub your forehead bdefly to stimulate circulation. Put
on the headband as shown at the top of this page.
Make sure that the sensor window is centered on your
forehead, and that there is no hair between the sensor
window and your forehead.
Sensor
He.band,
PROPER ORIENTATION OF THE PULSE SENSOR
The transmitter on the pulse sensor is angled down-
ward, as shown below. For the pulse sensor tofunc-
tion properly, the transmitter must be pointed within
30° of the center of the console (the shaded area In
the drawing). If you tum your head too far away from
the console, the signal from the pulse sensor will not
be received.
GUIDEUNES FOR OBTAINING ACCURATE PULSE
READINGS
The Instructions on page 11 explain how the pulse
sensor is used with the console (see HOW TO USE
THE PULSE DISPLAY). For the best results, remem-
ber the following important guidelines:
1. Before putting on the headband, rub your forehead
for a.moment to stimulate circulation.
2. Make sure that the headband tits snugly around
your head, without being uncomfortable.. If the
headband Is too loose or too tight, your pulse may
not be detected.
To Next Page
Loading...
