Imesa ECC - Manufacturer Liability; Necessary Tools

K2950SCHEDESS_01 – K2950SCHEDESS_02 (E141203X)
25/08/2015
3
and in compliance with European standards
on the installation and repair of industrial
machines.
The here describe tumble dryer must be used
for a professional drying of garment and
linen.
Any other use is forbidden if not previously
authorized in written by the manufacturer.
Do not introduce into the machine items other
than the one to be dried. Linen to be dried
must not have been in contact with
hazardous material such as explosives,
detonating and inflammable. In this case the
linen must be rinsed, aired or partially dried.
It is forbidden to dry linen soaked with
substances manifestly dangerous for the
operator health, such as poison or
carcinogenic products.
Do not approach the machine with
combustible or flammable material in order to
avoid the risk of fires and explosions.
Always stick to the drying instructions on the
linen.
The use of the machine is forbidden for
people under 14 years age.
Additional external connection to the
machine, if not duly performed, release the
manufacturer from any responsibility.
These instructions do not cover all
possible risks. User must always pay
high attention and respect carefully the
rules.
3. MANUFACTURER LIABILITY
The instructions written in this manual are not
replacing, but completing the duties deriving
from the safety and accident prevention laws.
With reference to what is written in this
manual, the manufacture is not responsible
for:
 Use of the machine not in compliance
with the EU law in matter of safety
and accident prevention.
 Wrong machine installation.
 Missing of the ordinary and scheduled
maintenance.
 Disregarded or not correct application
of the instruction written in the
manual.
 difetti di tensione e di alimentazione
di rete.
 Not authorized modifications to the
machine.
 Machine used by not authorized
personnel.
 Not correct installation of the kit.
4. NECESSARY TOOLS
The below listed tools, necessary to install
this kit, are not supplied with this kit, as they
are part of a standard technician kit.
 Cordless screw gun;
 Cross headed insert;
 TORX T30 and T40 screwdriver or insert
for screw gun;
 Key No. 8 and No. 10;
 Drill insert 5,5 mm diameter;
 Stepladder.