2) Attach the Vortex to a Windows PC or a Mac using a standard Micro-USB cable
(ensure that this is a full USB cable, and not a power-only cable shipped with some
products)
3) Start vortex-configurator from chrome://apps/
4) Make sure the right COM port is selected and press the Flash Firmware button.
5) Point to the update file (OSD_vX.X.X.X.fw) downloadable from the Vortex 250 product
page on the ImmersionRC website, and start the update.
If during a previous upgrade you had a problem causing the OSD to be bricked, you can still
recover from this state using the procedure below:
Upgrade procedure for bricked OSD
1) Press and hold fusion board button.
2) Plug Lipo ( while still holding the fusion board button ).
3) Release fusion board button after 2 seconds.
4) Plug to USB
5) Start vortex-configurator from chrome://apps/
6) Make sure the right COM port is selected and press the Flash Firmware button.
7) Point to the update file downloadable from the Vortex product page on the
ImmersionRC website, and start the update.
To Next Page
Loading...