12
In case these values are not proposed again or the above picture is not shown after the switching on, please
contact immediately our After Sale Service, since this could represent a bad working of the sieve shaker.
5.06 OPERATING MODE
The working mode of the sieve shaker is visualised on the numerical display (C8) as specified in figure 6.3-I
(for the decoding of the visualised value consult the list here below).
MODE DESCRIPTION SETTABLE VALUES
L
Indication of the remaining time to the end of the test
---
T
Indication or selection of the sieving time
1 – 999 min.
H
Indication or selection of the vibrating intensity
0 – 99
F
Indication or selection of the ON time
1 – 999 sec.
C
Indication or selection of the sieving mode
0 = Intermittent
1 = Continue
5.07
SWITCHING THE APPLIANCE ON
By pressing this key, the sieving procedure is activated according to the setting up made by the operator.
5.08
SWITCHING OFF
At the end of a test cycle, follow these instructions in order to switch off the appliance:
1. Remove all the sewers and thoroughly clean the appliance from any possible specimen residual.
2. To switch off the appliance, put the Main Switch (C1) on the “0” position.
5.09
EMERGENCY STOP
Whenever it is necessary the operator can stop the test immediately by positioning the Main Switch (C1) on “0”.
WARNING
Remind that the test interruption causes its complete cancellation.
5.10
START UP AFTER EMERGENCY
WARNING
DANGER
Before starting the machine up again, find and solve the problem, which
led to an emergency stop.
To start the machine, put the Main Switch (C1) on the “I” position. This will reset the appliance to its standard
functions.
5.11 STOP COMMANDED BY SAFETY CIRCUIT
The test execution can be interrupted by the safety systems in particular conditions.
The appliance is equipped with the following security disposals:
SAFETY GUARDS
The Sieve Shaker can be equipped with a safety system (OPTIONAL) formed by a wooden box and by a
micro switch that is activated by the box opening. As soon as the micro switch is activated an electronic
device disconnects the feeding to the electromagnet (B13).
In this way the machine is stopped.
5.12 PROGRAMMING
WARNING
Do not try to operate the appliance without having carefully read and learnt this
manual in all its parts.
The sieve shaker has been studied in order to satisfy any operator’s need by means of its easy and accurate
setting procedures. The parameters that can be modified are:
To Next Page
Loading...