16
1. Press the key . The figure on the numeric display (C8) shall blink.
2. Press the key to increase the value or the key to decrease it and to set up
the value 1. The led is now blinking, showing that the value is under modification.
3. Press several times the key
until you come back to mode L. Confirming the data
storing, the led stops blinking.
NOTE
In the intermittent mode, the total sieving period includes the pauses too.
If the user selects a sieving time of 10 minutes, the appliance will stop working after 10
minutes, either in the intermittent or in the continuous mode.
5.13 TEST START UP
Before using the appliance regularly check it is working correctly by carrying out at least one complete empty cycle
according to the previous instructions.
Should there be any problem consult the chapter “DIAGNOSTICS”.
If the instructions in this manual do not provide the solution to the problem, contact Sales Assistance.
5.14 PRACTICAL EXAMPLE OF USAGE
Hereunder we describe a standard-procedure that allows even to an operator without a wide
experience to use the Sieve Shaker in a correct way:
1. Tool up the Sieve Shaker in a proper way, as suggested in the chapter “TOOLING UP” of the
present manual.
2. Use the key
to select the mode L.
NOTE
The key can be activated only in L mode.
3. Start up the appliance, acting on key . On the numeric display (C8) the count down for
the residual sieving time is shown.
4. During the working it is possible to verify the selected values for each parameter:
• Press the key
until on the display (C8) appears the desired mode. At this step
the operator can read the corresponding values.
To Next Page
Loading...