© Copyright 2007 IMS Company. All rights reserved. An ISO 9001:2000 Registered Quality Company
20
WIRING DIAGRAM FOR WL1250B
WIRING DIAGRAMS
Loader. DO NOT apply direct heat as damage will result.
Allow filter to air dry completely, normally 24-48 hour period @ 70° F or lower. DO NOT dry filter inside of the5.
residual has been removed.
Rinse thoroughly, from the inside straight through to outside, under low-pressure stream of water. Rinse until all soap
4.
45° to filter surface. Water stream must not exceed 70 psig.
DO NOT SCRUB.
Remove from solution and flush with stream of clean low-pressure water. Hold hose end/nozzle away from and at3.
Ivory®, Joy® or Palmolive®. Allow to soak for ten minutes.
Place filter in a container with 2%-3% (approximately 4 oz per gallon of water) solution of mild dish soap such as
2.
Pre-clean and brush Cartridge as described in Dry-Method above to remove excess dust particles.1.
Additionally Cartridge Filters can be cleaned using a mild detergent and air-dried.
CLEANING: WET METHOD
To Next Page
Loading...
