Introduction 2 Section - 1
4004i - Manual # 99904386
Introduction
This manual includes parts, specications, and installation information for your particular crane. It is your
responsibility to maintain and operate this unit in a manner that will result in the safest working conditions possible.
Warranty of this unit will be void on any part of the unit subjected to misuse due to overloading, abuse, lack of
maintenance and unauthorized modications. No warranty - verbal, written or implied - other than the ocial,
published IMT new machinery and equipment warranty will be valid with this unit. In addition, it is also the user’s
responsibility to be aware of existing Federal, State and Local codes and regulations governing the safe use
and maintenance of this unit. This crane was designed and built to meet the standards of ANSI / ASSE A10.31-
1995, Safety Requirements, Denitions, and Specications for Digger Derricks. Contact the American National
Standards Institute (www.ansi.org) for more information.
Throughout this manual, four means are used to draw the attention of personnel. They are NOTE, CAUTION and
WARNING and DANGER are dened as follows:
NOTE
A NOTE is used to either convey additional
information or to provide further emphasis for
a previous point.
CAUTION
A CAUTION is used when there is the very
strong possibility of damage to the equipment
or premature equipment failure.
WARNING
A WARNING is used when there is the
potential for personal injury or death.
DANGER
Danger indicates an imminently hazardous
situation which, if not avoided, will result in
death or serious injury. Danger is used in the
extreme situations.
For a safe work environment, treat this equipment with respect and service it regularly
To Next Page
Loading...
Need help?
General
