24
• DOK-DIAX01-TDA********-PRJ1-EN-E1,44 • 07.97
Irrespective of the type of main spindle controller, the interfaces of all
feedback and NC connections are identical as to terminal assignment
and designation. They are contained both in the documentation "Electri-
cal connections of main spindle drives" (No. 209-0042-4111) and in the
documentation "AC main spindle drives with controlled asynchronous
motor or frameless spindle motor; Applications Manual" (No. 209-0041-
4109).
The functions and signal levels related to these interfaces are also
identical irrespective of the main spindle controller. They are described
in the latter documentation.
The necessary electrical connections are dependent on
– the selected function options of the controller.
Fig. 14 illustrates the (standard) interfaces to be found on any main
spindle controller, listed according to the index code for the respective
connection diagram. Fig. 15 shows the assignment of the function
options of the controller to the respective connection diagram, according
to the listed index code.
The connection diagrams for feedback and NC connection can now be
found by searching for the index code (last column of Fig. 14 and 15) in
the documentation "Electrical connection of main spindle drives; Project
Planning", whose list of keywords contains these index codes.
Feedback and NC connec-
tions
2. Control cabinet design
To Next Page
Loading...