38 INSTINCT User Manual rev 01 04/18
Troubleshooting Section 5
Boil Test
To test the quality of a pan for induction cooking,
perform a boil test.
This test is not applicable to griddles and
braising pans. NEVER heat any cooking pan
on a griddle plate or in a braising pan.
(Test for 3.5kW or 5.0kW Induction Coil)
Perform a boil test to verify the performance of a
pan for induction cooking.
• Add one liter of cold water into the pan (op-
timal when use pan with bottom diameter of
24cm) and bring it to boil. Compare the total
boil time to the guideline below:
• 3.5kW Coil, approx. 140 seconds
• 5.0kW Coil, approx. 85 seconds
If time to boil exceeds the above guideline, then
the pan is not suitable for achieving optimal effi-
ciency. Please contact your supplier to purchase
suitable induction pans.
If the induction appliance does not function as
expected despite using quality induction pans,
refer to the troubleshooting charts.
Dangers avoidance in case of accidents
or malfunctions
To avoid hazards in the event of a malfunction
or accident related to the device, proceed as fol-
lows.
1. Disconnect the power supply from the circuit
breaker provided for the device.
2. Disconnect the mains plug of the affected
device to prevent it from being switched on
again.
n
DANGER
If the plug is not safely accessible, the de-
vice must be switched off at the main circuit
breaker.
To Next Page
