tina56e1-f (2015-09) 57
Remove gauge from the vacuum system and install the
protective lid.
Protective lid
6 Maintenance, Repair
Gauge failures due to contamination and wear and tear,
as well as expendable parts (e.g. filament), are not
covered by the warranty.
INFICON assumes no liability and the warranty becomes null
and void if any repair work is carried out by the end-user or third
parties.
6.1 Adjusting the Gauge
The gauge is factory calibrated. Due to long time operation or
contamination, a zero drift could occur. Periodically check the
zero and adjust it if necessary.
To Next Page
Loading...
