SRED ENCRYPTED MSR INFORMATION
Integrating the PCI PTS 3X SRED certified Infinea TAB M into your solution
requires proper maintenance of the Infinea TAB M.
This includes maintaining proper battery charge to prevent the Infinea TAB M
from unintentionally entering tamper detect mode. When the Infinea TAB M
battery becomes depleted or if the battery is removed, the magnetic read
head becomes disabled and renders the unit unusable. This will require the
unit to be sent back to Infinite Peripherals for servicing.
To prevent down time caused by the magnetic read head security feature
becoming disabled follow the recommendations below:
• Do not allow the Infinea TAB M battery to fully discharge.
• Do not attempt to remove battery from Infinea TAB M unit.
• Always place the Infinea TAB M on charging station when not in use for
extended periods.
The battery capacity and approximate time remaining before full discharge are
shown in the table below. These values do not include daily usage of your
Infinea TAB M and iOS device:
Warning:
• When the Infinea TAB M battery is fully discharged and enters the
tamper detect mode, the unit can only be re-enabled at an IPC
authorized service facility or at one of IPC’s location
To Next Page
Loading...