right of the status bar above the image, with the replaceable battery before the built-in
battery. Green indicates that the device is being powered, and gray indicates that the
device is not powered on.
If the replaceable battery is not installed, only a green built-in battery icon is displayed on
the status bar.
If the replaceable battery is installed and fully charged, it will be preferred. When the
replaceable battery is low, the device will switch to the built-in battery automatically.
When the device is connected to a USB, it will switch to the external power supply USB
automatically. At this time, a lightning-like charging icon is displayed on the built-in
battery icon, which indicates that the built-in battery is being charged.
When the device is in use, the replaceable battery can also be replaced. At this time, it
will switch to the internal battery automatically.
VII. External Power Supply
The Tube series supports external power supplies, such as the portable power source for a
mobile phone (5V).
Connect an external power supply to the USB port (9) of the Tube device;
Then, the device automatically switches to the external power supply and charge the
internal battery pack at the same time;
When the external power supply is turned off, the device switches to the replaceable
18500 battery for power supply. If no replaceable 18500 battery is installed or the battery
level is low, it will switch to the built-in battery pack, instead of shutdown.
VIII. Installation and Use
Fixed installation
WARNING! The lens of the device must not be pointed at any sources of intense
radiation energy, such as laser-emitting devices or the sun. This may damage the electronic
components in the device. Damage caused by failure to comply with the operating guidelines
is not covered under warranty.
To Next Page
Loading...
Need help?
General
