2
Table of Contents
Introduction 3
Connecting a computer 5
Required computer connections 5
Displaying a computer image 7
Adjusting the image 8
Connecting a video device 9
Displaying a video image 10
Shutting down the projector 12
Troubleshooting your setup 12
Using the keypad buttons 20
Using the remote control 21
Using the audio 22
Optimizing computer images 23
Presentation features 23
Optimizing video images 23
Customizing the projector 23
Using the menus 24
Picture menu 25
Settings menu 28
Maintenance 32
Cleaning the lens 32
Using the security lock 32
Replacing the projection lamp 33
Cleaning the lamp filter screens 35
Appendix 36
Projected image size 36
Important Operating Considerations for Safety
• Place the projector in a horizontal position no greater than 15 degrees
off axis.
• Locate the projector in a well-ventilated area without any obstructions
to intake or exhaust vents. Do not place the projector on a tablecloth or
other soft covering that may block the vents.
• Locate the projector at least 4' (1.2 m) away from any heating or cooling
vents.
• Use only InFocus-approved ceiling mounts.
• Use only the power cord provided. A surge-protected power strip is
recommended.
• Refer to this guide for proper startup and shutdown procedures.
• Warning: Hg – Lamp contains mercury. Manage in accordance with
local disposal laws. See www.lamprecycle.org.
• In the unlikely event of a lamp rupture, particles may exit through the
projector side vents. When the projector is turned on, keep people,
food, and drinks out of the "keep out" area under and around the pro
-
jector, as indicated by the "X" areas below.
Follow these instructions to help ensure image quality and lamp life over
the life of the projector. Failure to follow these instructions may affect the
warranty. For complete details of the warranty, see the Warranty booklet.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
