InFocus IN3924 User Manual

31
Controlling the projector through a LAN
environment
The projector supports Crestron
®
software. With correct settings for the
Network menu, you can manage the projector from a computer using a web
browser when
the computer and the projector are properly connected to the
same local area network.
Wired connection
Internet
IP Router
Configuring the LAN control setting
If you are in a DHCP environment:
1 Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the
projector and the other end to the RJ45 port .
2 Press Menu on the keypad or remote and then go to Advanced Menu > Setup
> Network menu.
3 Press v to highlight DHCP and press < or > to select On.
4 Press v to highlight Apply and press >.
5 Please wait for around 15 - 20 seconds, and then re-enter the Network page.
The IP address, Subnet Mask, Default Gateway, DNS and Mac Address
settings will be
displayed. Write down the IP address displayed in the IP
address row.
• If the Projector IP Address still does not display, contact your network
administrator.
• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,
Default Gateway, DNS and Mac Address settings will display 0.0.0.0. Make
sure the cables are properly connected and perform the procedures above
again.
• If you need to connect to the projector in its standby mode, set the Power
Saving Mode feature to Off.
If you are in a non-DHCP environment:
1 Repeat steps 1-2 above.
2 Press v to highlight DHCP and press < or > to select Off.
3 Contact your network administrator for information on the IP address, Subnet
Mask,
Default Gateway, DNS and Mac Address settings.
4 Press ^ or v to select the item you want to modify.
5 Press < or > to move the cursor and then press ^ or v to select the value.
6 Press v to highlight Apply and press > to save the settings.
• If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,
Default Gateway, DNS and Mac Address settings will display 0.0.0.0. Make
sure the cables are properly connected and perform the procedures above
again.
• If you wish to connect to the projector in its standby mode, be sure to
select RJ45 and obtain the IP Address, Subnet Mask, Default Gateway, DNS
and Mac Address information when the projector is on.

InFocus IN3924 Specifications

General

White Brightness	3000 lumens
Native Resolution	1024 x 768
Contrast Ratio	2, 400:1
Aspect Ratio	4:3
Throw Ratio Range	0.48:1
3D	yes
Minimum Screen Size	49 inches
Maximum Screen Size	74 inches
Minimum Distance	2 feet
Maximum Distance	3 feet
Video Input	vga, hdmi, composite video
Inputs	hdmi, composite video, ethernet, usb, vga
OS Compatibility	mac, windows

Weight and Dimensions

Depth	9.1 inches
Height	5.2 inches
Width	12.9 inches
Net Weight	9.9 pounds