5
Usage Guidelines
•
Do not look directly into the projection lens when the projector
is turned on. The bright light may harm your eyes.
NOTE: If the projector overheats
and turns off, you must wait about
30 seconds before you attempt to
turn it back on.
•
Do not block the grills on the projector. Do not place the projec-
tor on cloth table coverings, as they may get sucked up to the
vents. Restricting the air flow can cause it to overheat and turn
off.
•
Handle the projector as you would any product with glass
components. Be especially careful not to drop it.
•
Avoid leaving the projector in direct sunlight or extreme cold
for extended periods of time. If this happens, allow it to reach
room temperature before use.
•
This projector is not intended for use in a mainframe computer
room as defined in the Standard for the Protection of Electronic
Computer/Data Processing Equipment, ANSI/NFPA 75.
•
Transport the projector in a vendor-approved hard or soft case.
Part numbers for these cases are listed on page 52. Call your In
Focus dealer to order.
If You Need Assistance
The first place to look for help is in this manual. Be sure to check
the guidelines in “Troubleshooting” on page 44.
If this manual doesn’t answer your question, call your In Focus
dealer. You can also call In Focus Customer Service directly at
1-800-799-9911
. Customer Service is free between 5 a.m. and
5 p.m. PST, Monday through Friday. Service is available in North
America after hours and on weekends for a fee at
1-888-592-6800
.
In Europe, call In Focus in The Netherlands at
(31) 23-5540310
. In Singapore, call
(65) 740-6435
. Or, send us an
e-mail at
techsupport@infocus.com
Our World Wide Web address is
http://www.infocus.com.
Warranty
This product is backed by a limited one-year warranty. The
details of the warranty are printed at the back of this manual.
Longer term warranties can be purchased from your In Focus
dealer. Refer to page 52 for part numbers.
To Next Page
Loading...
Need help?
General
