Level 1
(Sub)
Level 2
(Sub)
Level 3
(Sub)
Level 4
(Sub)
Data Remark
Default Value
3D
3D Mode
@ Off
Gray out 3D - 2D, 3D Format and 3D Sync Invert while 3D
Mode is Off
On
Support auto 3D On and hide 3D Format while signal is HDMI
1.4a 3D
3D - 2D
@ 3D
L Only display left frame
R Only display right frame
3D Format
@ Auto
SBS SBS = Side by Side Half
Top and
Bottom
Frame
Sequential
3D Sync
Invert
Off Off / On
Aspect Ratio
4:3
16:9
16:10 Not supported in 1080p
LBX 1. LBX = L.Box
Native Original image without any scaling
@ Auto
Edge Mask 0 0 ~ 10
1. Save value into EEPROM
2. Overscan display area 0~10%
3. Remove the video encoding noise on the edge
4. VIDEO source default is 4
5. Gray out if four corners enable
Zoom 0 -5 ~ 25
1. Save value into EEPROM
2. Digital zoom from 0.8X~2.0X (-5~25)
3. Value mapping: -5 (0.8X), -4 (0.84X), -3 (0.88X), -2 (0.92X), -1
(0.96X), 0 (1.0X), 1 (1.04X), 2 (1.08X), 3 (1.12X), 4 (1.16X), 5
(1.2X), 6 (1.24X), 7 (1.28X), 8 (1.32X), 9 (1.36X), 10 (1.4X), 11
(1.44X), 12 (1.48X), 13 (1.52X), 14 (1.56X), 15 (1.6X), 16
(1.64X), 17 (1.68X), 18 (1.72X), 19 (1.76X), 20 (1.8X), 21
(1.84X), 22 (1.88X), 23 (1.92X), 24 (1.96X), 25 (2.0X)
4. Gray out if four corners enable
Image Shift
H. 0 -100 ~ 100
1. Save value into EEPROM
2. Shift projected image position horizontally
3. Gray out if four corners enable
V. 0 -100 ~ 100
1. Save value into EEPROM
2. Shift projected image position vertically
3. Gray out if four corners enable
Keystone
Four Corners
H Keystone 0 -30 ~ 30
V Keystone 0 -30 ~ 30
Auto
Keystone
On Off / On
Reset
55
To Next Page
Loading...
