37
Video Standard: when it is set to Auto, the projector attempts to automati-
cally pick the video standard based on the input signal it receives. (The
video standard options may vary depending on your region of the world.) If
the projector is unable to detect the correct standard, the colors may not
look right or the image may appear “torn.” If this happens, manually select
a video standard by selecting NTSC, PAL, or SECAM from the Video Stan-
dard menu.
Overscan: (video sources only) removes noise around the video image.
Sync Threshold Adjust: (progressive signals only) If a hardware device,
such as a DVD player, is not syncing properly with the projector, adjust this
option to help it to sync when connected to the projector.
The following four (4) options are for progressive and computer sources
only.
Phase: adjusts the horizontal phase of a computer source.
Tr ac ki ng : adjusts the vertical scan of a computer source.
Horizontal/Vertical Position: adjusts the position of a computer source.
Video Standard
To Next Page
Loading...
Need help?
General