37
Error Conditions
Not all commands are supported for all
projectors. If an unsupported
command is issued, the command will be ignored. If a command is received
that is not understood, a ‘?’ character will be returned indicating the
commandwas not understood.
Limitations
The projector cannot respond to commands coming in
at a high-rate.
Therefore, a delay must occur between commands to ensure that the
command gets properly executed. To assure the projector can process a
command, wait 3 seconds before entering the next command.
The Step column refers to increasing or
decreasing the menu bar position
since the On-screen Display is not an exact match of values. For example,
Step 2 changes the data by 2 through the CLI (Command Line Interface).
The menu bar is up (or down) by 1.
Read Command Examples
Function Commend Response
Brightness
(BRT140) Sets the brightness
to 140
Power (PWR0) Turns power on
Power (PWR1) Turns power off
Function Command Min Max Default Step
About (Source Info)
0: n/a
1: enable
ABT at W 0 1 n/a
Advance to next
Co
mputer Source
CAD+ at
RW
0 2 0: DVI
D.1: VGA1
D.2: VGA2
Aspect Ratio
0: Native
1: 16:9
2: 4:3
ARZ at RW 0 2 2
Aspect Ratio
Advance Co
mmand
ARZ+ at
RW
0 6 2
Aspect Ratio of
Cu
rrent Source
QAR at R
Auto Image
0: n/a
1: enable
AIM at W 0 0 1 n/a
Auto Power
0: disable
1: enable
APO at RW 0 1 0
Auto Source
0: disable
1: enable
ASC at RW 0 1 1
Auto Off Time
Setting
AOT at RW 0 6 0
Blank
0: off
1: on
BLK at RW 0 1 0
To Next Page
Loading...
