To Next PageTo Next Page
Need help?Do you have a question about the Infopia EasyGluco and is the answer not in the manual?
General| Blood Sample | Capillary whole blood |
|---|---|
| Measuring Time | 5 seconds |
| Measuring Range | 20-600 mg/dL |
| Battery Life | Approximately 1, 000 tests |
| Operating Temperature | 10-40°C (50-104°F) |
| Operating Humidity | 10-90% RH |
| Hematocrit Range | 30-55% |
| Sample Volume | 0.5 μL |
| Measurement Time | 5 seconds |
| Operating Conditions | 10-40°C (50-104°F), 10-90% RH |
| Sample Size | 0.5 μL |
| Memory Capacity | 300 results |
| Power | Two 3.0V lithium batteries (CR2032) |
| Battery | Two 3.0V lithium batteries (CR2032) |
Explains the procedure for using the check strip to verify the meter's proper function.
Details the steps required to calibrate the EasyGluco™ meter with test strips using code numbers.
Introduces the control solution for system verification and accurate results.
Step-by-step guide on applying control solution to the test strip and interacting with the meter.
Demonstrates how to prepare and use the lancing device to obtain a blood sample.
Lists all necessary items required before proceeding with blood glucose testing.
Explains how test results are displayed and the importance of recording them in the logbook.
Lists common error messages like 'Err', 'Er2', 'Er3' and their associated causes and solutions.
Explains the 'Lo' and 'HI' messages indicating hypoglycemia or hyperglycemia and recommended actions.
