Engineering Information
Playback of Messages
Performing a Test Call
Programming Telephone Nos
Quitting Engineer Mode
To play any of the messages previously recorded:
a) Press .
b) Press the number of the message to be played
(1to 4).
After a short interval the Informa will replay the
selected message. Message 1 is the location
message and Messages 2, 3 and 4 are alarm
messages.
To test that the telephone numbers have been set up
correctly the Informa can perform a test call. During
a test call the speaker will be turned on so that you
can hear how the call progresses. To generate a test
call:
a) Press .
b) Enter the telephone number (1 to 3) to be tested.
The Informa dials the number then plays
message 1 followed by message 2.
Listen for the acknowledge signal. If the
Informa receives a valid acknowledgement it
hangs up the line and lights all four LEDs
steadily. If it fails to receive an acknowledge-
ment it repeats its messages for the duration
of the message timeout, then hangs up the
line and flashes all four LEDs.
c) Press again to end the sequence.
Informa will automatically reset to the top level
of the Engineering menu.
Up to three telephone numbers can be programmed
into the Informa.
This does not include your Follow Me telephone
number, which is programmed when the system is
set.
ote: The Informa cannot contact the emergency
services directly. It will not accept any telephone
number starting with 999 or 112.
To program any of the three telephone numbers:
a) Press .
b) Select the telephone number (1 to 3) you want
to change.
c) Enter the telephone number. 21 digits are
allowed.The number is automatically saved
once the 21st digit is entered
If a number of less than 21 digits is required,
press Tel to end the entry of the number.
d) Press to add a pause of one second if
required. Each depression of equals one
digit of the 21 digits allowed.
e) Now press:
to accept the telephone number just
entered, if less than 21 digits.
to reject the number if you made a
mistake.
to accept the number just entered and
immediately make a test call to that number.
To delete a telephone number:
a) Press .
b) Select the telephone number to be deleted
(1 to 3).
c) Press .
Having completed all programming and test calls,
you can return the Informa to standby mode:
Press to leave engineer mode.
12
To Next Page
Loading...