Quick Start the Halley5 Development Kit
X2000 Development Kit User Manual
Copyright® 2005-2021 Ingenic Semiconductor Co., Ltd. All rights reserved.
make sure it’s under USB boot mode (by pressing the USB boot key SW3 and the reset key SW6). The BOOT
key (SW3) is used to control X2000 to boot from USB mode. Keep pressing down the BOOT key (SW3) then
reset the board, X2000 will be under USB boot mode and start downloading firmware from PC through the USB
port (J2). Then release the BOOT key SW3.
Please find more detailed instructions for using the burning tool (USBCloner) from the USBCloner guide.
To Previous Page
Loading...
