EasyManuals Logo

Ingenico group AXIUM DX8000-BASE-W2 User Manual

Ingenico group AXIUM DX8000-BASE-W2
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
18
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
In accordance with the Innovation Regulations, Science and Canada Economic Development, this radio
transmitter may operate with an antenna of a type and maximum (or lower) gain approved for the
transmitter by Industry Canada. In order to reduce the risk of radio interference to other users, the
antenna type and its gain must be chosen so that the equivalent isotropically radiated power (e.i.r.p)
does not exceed the intensity required by the antenna establishing a satisfactory communication.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
5GHz Wifi should be used indoor only.
Le Wifi 5 GHz doit être utilisé à l'intérieur uniquement
Exposition aux RF
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator&
your body. This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Le rayonnement de la classe b repecte ISED fixaient un environnement non contrôs.Installation et
mise en œuvre de ce matériel devrait avec échangeur distance minimale entre 20 cm ton corps.Lanceurs
ou ne peuvent pas coexister cette antenne ou capteurs avec d’autres.
Environment (WEEE, Batteries and packaging)
This product is labeled in accordance with European Directives 2012/19/EU concerning Waste Electrical
and Electronic Equipment (WEEE) and 2013/56/EU concerning Batteries and Accumulators. Those
provisions are requiring producers and manufacturers to become liable for take-back, treatment and
recycling upon end of life of equipment and batteries.
THE PRODUCT
The crossed-out waste bin stuck on the product or its accessories means that the product
belongs to the family of electrical and electronic equipment, and waste batteries must not
be thrown away but collected separately and recycles.
Please contact your retailers for more detailed information about the compliance solution
in place for disposing of your old product and used batteries.
Packaging waste must also be collected separately to assure a proper disposal and recycling.
In this way you can participate in the re-use and upgrading of Electrical and Electronic Equipment Waste,
which can have an effect on the environment and human health.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ingenico group AXIUM DX8000-BASE-W2 and is the answer not in the manual?

Ingenico group AXIUM DX8000-BASE-W2 Specifications

General IconGeneral
BrandIngenico group
ModelAXIUM DX8000-BASE-W2
CategoryTouch terminals
LanguageEnglish

Related product manuals