icmp • 900011533 R11 000 02/1613 7/20
Copyright © 2013 Ingenico
All rights reserved
3.3. EC standard compliance marking
EC standard compliance marking certifies that icmp, the product stipulated below:
• complies with the basic requirements of European Directive 1999/5/CE, known as the
«R&TTE Directive» concerning Radio Frequency equipment and telecommunications
terminals with respect to:
– Health and safety protection of the user and all other persons
– EMC protection
• conforms to the following harmonized standards :
– IEC/EN 60950-1 : Electrical safety of data processing equipment including electrical
office equipment. Issue 2006 + A11 2009 + A1 2010 + A12 2011
– EN 55022 : Data processing equipment – Radio electric disturbance characteristics -
Limits and measurement methods. Issue 2010
– EN 55024: Data processing equipment – Immunity characteristics - Limits and
measurement methods. Issue 2010
• complies with the following specification:
– EN 300328 : (BT + Wi-Fi) Electromagnetic compatibility and Radio Spectrum
– EN 302291 : Electromagnetic compatibility and Radio Spectrum matters
– EN 301489: Electromagnetic compatibility and Radio Spectrum matters
3.4. FCC & IC Compliance.
FCC & IC has a specific naming.
The references uses for FCC & IC certifications are:
icm122-01T2263A (Bluetooth only):
• FCC_ID: XKB – ICM122BT
• IC Number: 2586D – ICM122BT
icm122-11T2265A (Bluetooth + Contactless):
• FCC_ID: XKB – ICM122BTCL
• IC Number: 2586D- ICM122BTCL
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
To Next Page
Loading...
Need help?
General
