icmp • 900011533 R11 000 02/1613 8/20
Copyright © 2013 Ingenico
All rights reserved
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
15.19 (a) (3)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference and
2) This device must accept any interference received, including interference that may cause
undesired operation of the device.
Industry Canada (IC) Statement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p) is not more
than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This device complies with FCC and Industry Canada radiation exposure limits set forth for
general population. This device must be installed to provide a separation distance of at
least 20cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter.
CAUTION
The user is cautioned that any changes or modification not approved by INGENICO could
void user’s authority to operate the equipment.
3.5. Bluetooth SIG
This equipment is compliant with:
• System specification V1.2/2.0/2.0 + EDR/2.1/2.1 + EDR 3.0/3.0 + HSCRF.TS/2.1.E.51 06
August 2009
• SSP protocol
To Next Page
Loading...
Need help?
General
