35
Service Requirements
Operator Access (ESD Precaution)
This is an Electrostatic (ESD) sensitive
area. As a minimum, the operator should
be ‘Electrostatically Discharged’ via his/
her hand to a suitable metallic earthing
point prior to opening this area.
There are no other user serviceable
parts inside. In the event of equipment
malfunction, unplug the power supply.
It is the responsibility of users requiring
service to report the need for service to
the authorised Service Agent.
Maintenance
Cleaning the Case
• Do not allow any water to enter inside
the case. Remove any dust from the
case using a damp cloth. To clean o
accumulated dirt and grime, use a
damp cloth that has previously been
dipped in mild soap and water. Wring
out thoroughly to remove excess water
before use
• Do not use solvents, cleaning uids
or abrasives. These materials could
damage the plastic housing and any
exposed contacts
External Power Supply
• This apparatus is intended for use when
supplied with power from a low voltage
external power supply
• Only an Ingenico approved power
supply (CE Marked) specied for use
with this Terminal may be used
• Since this product does not have a
disconnect device (ON/OFF switch), the
Terminal and Power Supply must be
installed near a suitable power socket,
which is easily accessible
• In the event of a hazard or malfunction,
the Power Supply Unit should be
switched o at the socket before being
unplugged from the mains
• The power supply output lead should
only be plugged into the product power
input socket
• The power supply will provide adequate
power for the Terminal. The user
should ensure that all other auxiliary
apparatus, drawing power from the
host, does not overload the power
supply
• Operate only from a power source as
specied on the Power Supply Unit
A damaged mains cord (if not a
replaceable type) or low voltage
secondary input lead cannot be replaced
by the user, the unit must be returned to
the authorised service agent for essential
repairs and/or replacement.
Connections
Interconnection to other equipment via
the externally accessible ports on the
Terminal must only be made as follows:
Power Supply Input: Operates at Safety
Extra Low Voltage (SELV). Connect only
to an Ingenico approved Power Supply
(CE Marked) specied for use with the
Terminal.
Port(s), 6 way: The RS232 type port(s)
operate at SELV and must only be
connected to a module of the same type
i.e. SELV.
Public Switched Telephone Network
(PSTN) Line, 6 Way: MUST only be
connected to a PSTN socket e.g.
Telephone wall socket, PBX etc.
Under no circumstances must the PSTN
cable be inserted into the RS232 ports.
Take due care when attaching cables.
To Next Page
Loading...
Need help?
General
