Important safety instructions provided by the
manufacturer, Ingenico Ltd.
(continued)
36
External Cables
DO NOT use any other external cables
and/or cable lengths (must be less than
3 metres long) other than those specied
and/or supplied by the manufacturer.
Ensure all cables are routed to prevent
damage or accidental contact.
Modem
General Description
The Terminal has an integral modem
that allows the Terminal to transfer
transaction data to card companies host
computer systems.
The internal modem supports: CCITT
V22bis/V22/V21/V32, V32bis, V34 data
transfer protocols. It has an automatic
dialling facility.
Disclaimer
This equipment has been designed for
connection to the local Public Switched
Telephone Network (PSTN).
The apparatus must not be subjected to
any modication, in any material way,
unless authorised by Ingenico. Nor must
it be used with:
• Internal Modem Software that
has not been formally accepted by
the manufacturer
• External control Software or external
control equipment which causes
operation of the modem or associated
call set up equipment to contravene the
requirements of the PSTN Network
Systems to which the Modem
may be connected
This Modem is only approved
for connection to the following
telecommunications systems:
• The Public Switched Telephone Network
(PSTN)
• Any equivalent service run by any
Licensed Telecommunications
Network Operator
• Private Branch Exchange (PBX)
extensions, being a Branch
Telecommunications System operating
under a licence
The Modem is not suitable for shared
service or 1+1 carrier systems nor as an
extension to a pay-phone.
Note: It cannot be guaranteed that the
Modem will operate correctly under all
possible conditions of connection to
PBXs. Any cases of diculty should be
referred in the rst instance to Ingenico.
Connection
The modem is connected to the PSTN via
a standard plug and exible cord, which
requires a suitable compatible socket
(and adaptor if required).
To Next Page
Loading...
Need help?
General
