Inhep Digital Security IDS 404 - LOCATION 12 Arming Options

2 2 IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02
IDS404 INSTALLER MANUAL
01NOITACOLyaleDyrtnEyradnoceS
eulaV yaleD eulaV yaleD
0
.ces52.0
8
.nim4
1
.ces01
9
.nim5
2
.ces02
01
.nim01
3
.ces03
11
.nim51
4
.ces54
21
.nim81
5
)tluafeD(.nim1
31
.nim12
6
.nim2
41
.nim12
7
.nim3
51
.nim12
The secondary entry delay applies to the secondary entry/exit zone. If
a primary entry zone is violated, the primary entry delay is activated. If
a subsequent violation of a secondary entry/exit zone occurs, the
panel will continue to count down the primary delay. If a valid user
code is not entered during this period an alarm condition will occur.
11NOITACOLsnoitpoeludomnoisnapxE
eulaV noitcA
0
tluafeD
tneserpeludomnoisnapxeoN
1tneserpeludomnoisnapxE
3lenapnodelbaneenozreprepmatdnatneserpeludomnoisnapxE
senoz
If an expansion module has not been connected, a value of [0] must be
programmed into this location.
If a value of [0] has been programmed into this location, please note:
! If using double end-of-line resistors, program both zones eg.
program zone 1 and zone 1a in locations 1 to 8.
! If using single end-of-line resistors, program one zone eg. program
zone 1 OR zone 1a in locations 1 to 8.
If a value of [1] has been programmed into this location, please note:
! Single end-of-line resistors must be used on all panel zones in
this mode. In locations 1 to 8, the panel zones are 1 to 4 and
expansion module zones are zones 1a, 2a, 3a and 4a.