Inhep Digital Security IDS 404 - Page 24

IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02 23
IDS404 INSTALLER MANUAL
If a value of [3] has been programmed into this location, please note:
! Double end-of-line resistors must be used on all panel zones in
order to detect a tamper.
21NOITACOLsnoitpOgnimrA
eulaV mrAkciuQ
tixehctiwsyeK
yaled
gnimradecroF
kcolBssapyB
elbasiD/elbanE
0
####
1
tluafeD
$
# # #
2
#
$
##
3
$$
##
4
##
$
#
5
$
#
$
#
6
#
$
$
#
7
$
$
$
#
8
###
$
9
$
##
$
01
#
$
#
$
11
$
$
#
$
21
##
$$
31
$
#
$$
41
#
$
$$
51
$$
$$
$
delbanE
#
delbasiD
The quick arm option allows the user to arm the panel by holding down
the [1] key until the keypad beeps. Using the quick arm key initiates
an arming cycle as if a valid user code has been entered. User code 1
will be reported if the quick arm key is used.
The key-switch exit delay option enables or disables entry/ exit delays
with key-switch arming. See Section 5 in the User Manual for
information pertaining to key-switch arming.
Forced arming allows the panel to arm with violated zones e.g. an
open window. Once the panel arms, a violated zone will bypass