2 4 IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02
IDS404 INSTALLER MANUAL
automatically. If a zone which has been automatically bypassed clears
while the panel is armed, the zone will become active i.e. the window
is pushed closed. Opening the window again will cause an alarm
condition to be registered.
If Bypass block has been enabled (by programming a value of [8] or
higher into this location) the panel will not allow any zones to be
bypassed. Attempts to bypass zones (by pressing the [
!!
!!
!] key) will
result in error beeps from the keypad.
31NOITACOLsnoitpOmrAyatS
eulaV noitcA
0
tluafeD
resuehtfiedomyatsehtnimrayllacitamotualliwlenapmralaehT
nafonoitaloiv.e.i(enoztixe/yrtneehtesutonseoddnasmra
.)enoztixe/yrtne
1fonoitaloivonfineveedomyawaehtnimralliwlenapmralaehT
gnidloh(yekmrakciuqedomyatsehT.sruccoenoztixe/yrtnena
ehtnwod ]5[ .)delbasidoslasi
2fonoitaloivonfineveedomyawaehtnimralliwlenapmralaehT
yekmrakciuqedomyatsehtrevewohsruccoenoztixe/yrtnena
.evitcasniamer
The stay mode allows the user access to certain pre-programmed
“stay” zones while the panel is armed. Zones that are programmed as
stay zones (See Section 12 in the User Manual) will automatically be
bypassed when the panel is armed into the stay mode. The [5] key will
arm the panel in stay mode with no exit delay.
41NOITACOLsnoitpOcinaPdapyeKtneliS
eulaV noitcA
0
tluafeD
)cinapelbidua(delbasiD
1)cinaptnelis(delbanE
The value programmed into this location affects the keypad panic and
dedicated panic zone.
To Next Page
Loading...