IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02 43
IDS404 INSTALLER MANUAL
931NOITACOLedocgnitropernwod-tuhSenoZ
The zone shut down code will be reported if the system is armed and a
zone is automatically bypassed as a result of multiple violations of that
zone while the panel is armed. The number of permissible violations is
dependent on the value programmed into location 160. The zone
number will be appended to this reporting code to provide the 2nd digit
of the reporting code.
041NOITACOLedocgnitroperlecnaC
If the siren is sounding and the siren is cancelled by either a valid user
code or key/ remote, a cancel code will be reported. A silent alarm or
silent panic will not cause the cancel code to be reported. The user
number will be appended to this reporting code to provide the 2nd digit
of the reporting code.
141NOITACOLedocgnitroperlarotseRenoZ
If the panel is armed and a violation of a zone occurs followed by the
zone returning to the normal (non alarm) state, a zone violation
followed by a zone restoral will be reported. The zone restoral code
indicates that the zone has returned to the ready condition. The zone
number will be appended to this reporting code to provide the 2nd digit
of the reporting code.
341-241SNOITACOLedocgnitroperetelpmoCdaolnwoD
This code will be sent once a successful download to a panel has
been completed.
541-441SNOITACOLedocgnitroperliaFMLT
This code will be sent if telephone line monitoring is enabled and the
line voltage drops below 9V for more than 30-60 seconds. A failure
condition will be logged in the event log and if armed in the away mode
the siren will sound. NOTE: A TLM failure indicates that the telephone
line is either not functional or not present. This reporting code should
only be used in conjunction with a radio linked to the dialler.
741-641SNOITACOLedocgnitropererotseRMLT
This code will be sent once telephone line monitoring has been
restored.
To Next Page
Loading...