inVoca User Guide - Page 19
SPECIAL FEATURES
Fast Volume™
Fast Volume is a unique feature of inVoca that makes remote control
of volume especially fast and convenient. Fast Volume sends multiple
volume up or down commands with a single button push or just one
spoken command. To use Fast Volume simply press [¢] ÿ [V+]
(louder) or [¢] ÿ[V-] (softer) to have inVoca send four volume up
or down commands at one time. For even faster volume adjustment,
[Æ] ÿ[V+] or [Æ] ÿ[V-] sends eight volume up or down
commands.
To train inVoca to use Fast Volume:
1. Be sure the room is reasonably quiet.
2. Press and release the [Train] button
3. inVoca will prompt you by saying "Say a word"
4. Wait for the LED to light up green before you speak.
5. Say a one or two word voice command. For example, "Much
Louder"
6. The inVoca will ask you to repeat the command.
7. Say the same command again.
8. If the two commands match, inVoca will say "Press a button."
9. Press and release [¢], then press [V+]. inVoca will say,
"Button accepted. Press another button.” Press [Train].
inVoca will respond with “button assigned.
Repeat the above steps with the voice command "Very Soft," and with
the button sequence [¢] ÿ [V-] for rapidly lowering the volume.
L Please note: inVoca will need one or two seconds to send the
entire string of volume up or down commands to avoid sending
commands faster than the television can receive them. For best
results, make sure the inVoca is pointing toward the television the
entire time the inVoca LED is red. 7
inVoca User Guide - Page 20
Channel Scan
Channel Scan gives you hands free channel surfing. Once you have
pressed the [SCAN] button or spoken the channel "scan" command,
inVoca will send out a [CH+] (Channel Up) or [CH-] (Channel
Down) command every few seconds until you issue another voice
command (such as "scan") or press any button other than 1-9, [CH+]
or [CH-].
The scan will be up if the last channel button you pressed was [CH+],
or down if the last channel button you pressed was [CH-]. You may
control the speed of the scan (that is, how long the TV will pause at
each station) by pressing buttons 1 - 9 while inVoca is scanning. The
range is one channel command every three seconds if you press button
1, one command every four seconds if you press button 2, ranging up
to one command every 12 seconds with button 9. You can press
[CH+] or [CH-] to switch directions.
L inVoca cannot listen for voice commands at the same time it is
sending infrared commands. If you try to issue a voice command to
stop the scan while the LED is red, signifying inVoca is transmitting,
it will not be able to hear your command, and inVoca will keep
scanning. To avoid this it is recommended that you do not set the
scan rate at too fast a speed, and avoid issuing commands while the
LED is red. 7
Punch Through
Some TV, VCR, cable box, and satellite receiver controls may work
at the same time, depending on the type of TV, VCR, and cable box
that you use. For example, with Punch Through, even after you have
pressed the [VCR], or [CBL/SAT] buttons, the volume control may
still control the television, reducing the need to push the [TV] button.
Availability of this feature will vary with the type of entertainment
devices you are using.
To Next Page
Loading...