Press LED flashes Comment
inVoca User Guide - Page 33
[Learn/M][Learn/M]
2 end of first string
[0][0]
1
[4][4]
1
[Learn/M][Learn/M]
2 end of second string
[1][1]
1
[2][2]
1
[PROG][PROG]
3 end of macro
(Note: To reduce keystrokes you should not press [Learn/M] before
[PROG] at end of macro.)
SPECIAL COMMANDS
Delay
On rare occasions, you may find an entertainment device which
requires a pause between commands for a macro to operate properly.
To provide a pause of ½ second between two commands in a macro,
press [Æ] followed by [PAUSE].
Word Spotting
inVoca offers a powerful voice recognition technology called Word
Spotting, which allows it to recognize commands even in the middle
of a sentence. Word Spotting is useful if inVoca is responding to loud
background conversation in the room or if the TV is very loud, and
adjusting the microphone sensitivity does not help. The word spotting
function is initiated by the programmed keyword(s). Word Spotting,
however, could cause inVoca to respond to command words spoken
by other people in the background, or even conversation on the
television. To turn Word Spotting on or off, press [Æ] followed by
[AUTO]. The LED will flash once when Word Spotting is turned off,
and will flash twice when Word Spotting is turned on.
To use Word Spotting, you should program inVoca for the keyword
that you want to use. For example if you set up your keyword to be
inVoca User Guide - Page 34
'remote' and enable Word Spotting, when you wake up inVoca, the
LED will light orange to let you know that it is listening for a
keyword. Once it recognizes the keyword the LED will turn
green indicating it is listening for a command. For example, if the
keyword is 'remote' even if inVoca is awake, it will ignore any
commands until it hears the word 'remote'.
Reset inVoca
You may wish at some point to completely erase all of the
programming and set up of the inVoca. You may do this by pressing
[Æ] followed by [REC] (inVoca will beep), then pressing [Æ]
followed by [REC] again. (The LED will turn orange, then after a
brief pause, inVoca will respond with the word "erased.") Caution:
this will erase all set-up information, voice commands and macros.
inVoca will be reset to its default settings.
Adjust Wake Time
To maximize battery life, the inVoca will "sleep" when not in use and
is awakened to listen for voice commands when you press the
[Wake_up] button. Normally, when you first wake up inVoca, it will
remain awake for 60 seconds. The Wake time may be lengthened as
follows:
1. Press [AUX] The LED will flash red once.
2. Press [PROG] The LED will flash red twice.
3. Press [5] The LED will flash red once.
4. Press [PROG] The LED will flash as follows:
1 flash = 1 minute
2 flashes = 5 minutes
3 flashes = 10 minutes
4 flashes = 30 minutes
5. Press [5] ÿ[PROG] Repeat steps 3 and four to change the
wake time
6. Press [AUX] Press [AUX] to exit wake time setup.
To Next Page
Loading...
