inVoca User Guide - Page 27
8. If the two words match, inVoca will say "keyword assigned."
If voice commands were programmed prior to the first keyword,
then they will all be assigned to the first keyword.
L You can add Personalities at any time, even if you have already
trained inVoca to operate without having assigned a Personality. If
you program a set of voice commands, and then record a keyword,
inVoca will associate all the existing commands to the first
Personality recorded. After that, you must identify yourself before
you record any new commands to insure that they are added to the
correct personality. If you have trained inVoca to recognize a large
number of commands, you may wish to erase them, then re-train
inVoca with the commands for each personality. 7
If personalities are programmed, inVoca will normally "wake up"
listening for the last personality used. That is, if "Daddy" was the last
personality used, inVoca will wake up assuming that it is still being
operated by "Daddy." To change users, press and release the [¢]
button then press the [WakeUp] button. The LED will light orange
which means that it is listening for a keyword to identify the
personality. Once it recognizes a keyword the LED will light green
and inVoca will remember the new personality until you change it
again.
Switching to a Different Personality
If several family members typically take turns using inVoca, you may
change the operation so that, if personalities are programmed, inVoca
will always wake up listening for a new keyword. To do this, Press
and release the [¢] button then press the [TV/VCR] button. The LED
will flash twice.
In this mode of operation, the inVoca LED will turn orange when
inVoca has been awakened by pressing the [Wake_up] button.
inVoca then waits for you to identify the personality that you want to
use. Say the keyword (personality) that you programmed. If inVoca
recognizes the keyword, it will change the LED to green. inVoca will
inVoca User Guide - Page 28
listen for a keyword for 30 seconds. If it doesn't hear a valid keyword
in 30 seconds it will turn off the LED and go back to sleep.
If it does hear a keyword, inVoca will listen for voice commands for
the selected personality only for a period of 60 seconds. If it hears a
legitimate voice command, it will transmit the appropriate IR
command and reset its 60-second timer. The LED will be Green while
it is listening for voice commands and red while it is sending IR
commands.
You may change the operation back by pressing the [¢] button then
press the [TV/VCR] button again (the LED will flash once).
To erase a keyword (“personality”):
1. Press and release the [Æ] button, then press [REW].
2. inVoca will respond with “Beep. Say a keyword.”
3. Say the keyword you wish to erase.
4. inVoca will respond with “keyword erased.” (Note: erasing a
personality also erases the commands associated with the personality.
inVoca Prompts
The inVoca Remote Control gives you a visual indication of its status
through its front panel LED, while friendly "voice prompts" talk you
through the process of setting up keys the way you want. inVoca
won't let you program commands that it can't understand. Following
is a summary of the prompts inVoca will provide:
inVoca will
respond with
this prompt
When you
press this
button
Comment
Say a word
[Train]
You may now record a voice
command
To Next Page
Loading...