inVoca User Guide - Page 25
Auto-Mute
When enabled, Auto-Mute sends a Mute command to the television,
thus making the room quiet so that inVoca will better understand
voice commands.
inVoca offers two alternative Auto-Mute modes. In the full Auto-
Mute mode, any time inVoca wakes up through the user pressing the
[Wake_up] button, inVoca will send a mute signal. In the "Qualified
Auto-Mute" mode, inVoca sends a mute signal whenever it hears a
valid keyword. You may sequence through the Auto-Mute modes as
shown below. The LED will indicate whether Auto-Mute is on, and
if so, which Auto-Mute mode is selected by flashing as shown.
Press Then
Press
Auto-Mute Mode LED will
flash
[¢] [Mute]
Full Auto-Mute 2 times
[¢] [Mute]
Qualified Auto-Mute 3 times
[¢] [Mute]
Auto-Mute Off 1 time
You may turn the volume back on by issuing a Mute command.
Special buttons
A very limited number of entertainment devices (such as cable boxes)
require buttons that are not displayed on inVoca. Two additional
button functions available are:
Display To send the Display command to your device, press
[¢] ÿ[Prev]
Reset To send a Reset command to your device, press
[Æ] ÿ[Stop]
inVoca User Guide - Page 26
ADVANCED VOICE OPERATION FEATURES
Personalities (keywords)
L If only one person is to use the inVoca, personalities are not
required. 7
When Personalities are programmed, inVoca can learn independent
voice commands for as many as four people and each family member
can program inVoca for his or her favorite channels. inVoca will only
search for voice commands for the currently active personality. This
can be helpful since a child's voice is so much different than an adult's
voice. The use of Personalities is optional but it will increase the
recognition accuracy for households where more than one person will
be using the inVoca remote control.
Setting up Personalities (optional)
"Personalities" are assigned through the use of "Keywords" to identify
individual users. To train the inVoca to recognize a user ("train a
keyword"):
1. Be sure the room is reasonably quiet.
2. Press and release the [¢] button then press the [Train]
button
3. inVoca will prompt you by saying "Say a keyword"
4. Wait for the LED to light up green before you speak.
5. Say a one or two word voice command. For example,
"Daddy."
6. The inVoca will ask you to repeat the command.
7. Say the same word again.
To Next Page
Loading...