inVoca User Guide - Page 35
SEARCH MODES
inVoca offers two search modes, "Auto Search" and "Manual
Search," to help you find the correct code for your entertainment
device. When searching for a code using Auto Search or Manual
Search you must first select the appropriate device type.
The [TV] button will search through TVs and TV/VCR combos.
The [VCR/DVD] device button will search through VCRs, TV/VCR
combos and DVD players.
The [CBL/SAT] device button will search through cable boxes and
DSS receivers.
The [AUX] device button will search through all codes.
Auto Search for Your Device Code:
If you have trouble programming the device code for inVoca, or can't
find the correct code in the manual, inVoca can cycle through the
available codes automatically to help you locate a usable code. It is
recommended that this feature be used only when all other methods
have failed, as it may take from 7 to 18 minutes for the remote to
locate the correct code, depending on the device list that you are
searching.
1 Power On Manually turn on the device that you want to
auto search (TV, VCR, etc)
2 [TV], [VCR],
[CBL], or
[AUX]
Press the device key for the device type for
which you are searching. For example, to
search for a TV code, press TV (1 Flash).
3 [PROG] Press the [PROG] button once (2 Flashes).
4 Make sure that the remote is aimed directly at
the device you want to control.
5
[Auto]
Press the Auto Search button (1 Flash).
inVoca will now search through the library for the target device code.
Every 3 seconds the remote will prompt you by flashing the light, and
inVoca User Guide - Page 36
the remote will test the new code by attempting to turn the device
power off.
6
[PROG]
When the target device turns off press the
[PROG] key. The code will be stored in
memory. (3 Flashes)
After you have pressed [PROG], check the other buttons (such as CH+
and VOL+) to be sure they all work with the target device. If they do
not, repeat steps 1 through 6. When the auto search is re-started the
search for the target device will begin where it was last stopped.
To stop the "Auto Search" press any key except the Auto Search key.
Manual Search
You can manually cycle through the device codes to find a code that
works with your TV, VCR, Cable Box, DVD, or DSS.
1 Power On Manually turn on the device that you want to
auto search (TV, VCR, cable box, DVD, or
DSS receiver).
2 [TV], [VCR],
[CBL/SAT], or
[AUX]
Press the device key for the device type you
want to search for. For example, to search
for a TV code, press TV once (1 Flash).
3 [PROG] Press the program button once (2 Flashes).
4 [0], [0], [0] Enter code 0,0,0. (1 Flash for each number
pressed). Test the remote, if it works, skip
step 5.
5
[PROG]
Press the [PROG] button to change to the
next device code. (3 Flashes) Every time
[PROG] is pressed the remote will change to
the next device code. Test the remote with
your entertainment device for each code.
6 [TV], [VCR],
[AUX], or
[CBL/SAT]
When you find a code that works with your
entertainment device, press the device key
again. This will lock in the code.
Once you find a code that works you should read back that code using
the Read Back feature so you can record the number for reference.
To Next Page
Loading...